Our 5 Step Pretreatment


Based on surface size and type.

Water Rinse

A Controlled fresh water rinse is necessary before drying.


Depending on the surface we use a special conditioner.

Water Rinse

Regulated by a meter to maintain total dissolved solids.

Iron Phosphate

Parts are treated with iron phosphate.

Powder coatings are based on polymer resin systems, combined with curatives, pigments, leveling agents, flow modifiers, and other additives.  These ingredients are melt mixed, cooled, and ground into a uniform powder similar to baking flour.  A process called electrostatic spray deposition (ESD) is typically used to achieve the application of the powder coating to a metal substrate.  This application method uses a spray gun, which applies an electrostatic charge to the powder particles, which are then attracted to the grounded part.

After application of the powder coating, the parts enter a curing oven where, with the addition of heat, the coating chemically reacts to produce long molecular chains, resulting in high cross-link density. These molecular chains are very resistant to breakdown.  This type of application is the most common method of applying powders.  Powder coatings can also be applied to non-metallic substrates such as plastics and medium density fiberboard (MDF).